Gas Hot Water Repairs & Replacement in South Hurstville NSW

A renovation client wanted their old flued storage unit moved outside, so we ran a new gas line, installed a continuous flow unit and removed the redundant flue. Projects like that sit alongside day to day emergency hot water repairs, pilot and ignition faults, thermocouples and gas valves, leaking cylinders and TPR or tempering valve replacement. Routine servicing with anode, burner and TPR checks is part of the package too, on natural gas and LPG.

If the TPR valve on your storage tank is discharging a steady stream of water rather than an occasional dribble, treat that as urgent and give us a call. Closing the cold inlet will stop the loss of water until the gasfitter arrives, and the valve itself is a routine part carried on the van.

There is no need to guess at our boundaries. The local area and the suburbs around it are home turf, nearby towns are a regular drive, and rural LPG properties are all part of a normal week. A short call with your address settles it.

A hot water replacement is quoted job by job rather than off a fixed price list. A simple storage swap in an accessible spot costs less than converting to continuous flow with gas line and flue work. Every quote we give is written, free and itemised so you can compare it with confidence.

When the pilot on an older storage system keeps going out and the unit also sounds or smells different when it does fire, there may be a combustion problem rather than just a tired sensor. A blocked flue or dirty burner can disrupt the flame and the thermocouple together. Stop relighting it and have a licensed gasfitter check the system before using it further.

Every gasfitter who arrives at your door can show a current licence on request, and we encourage you to ask. Behind that licence sits liability insurance that covers the work and your property. The compliance certificate we leave with you is proof that the hot water installation was done by the right person in the right way.

Take a unit that is only a few years old and has stopped heating because the thermocouple has failed. That is a straightforward repair, and with the new part fitted the system should run reliably for many more years. Replacing a young unit over a single component would be a waste of a perfectly good cylinder, so we would fit the part, test the burner and pilot, and send you on your way.

Picture an older storage cylinder in the same spot being replaced with a new one of the same size. The old tank is drained and removed, the new unit connected to the existing gas and water lines, and the system tested, all within a few hours. Hot water for showers that evening is the norm for this kind of job.

Mention anything you have noticed to the technician, such as water taking longer to heat, a pilot that has gone out, rumbling from the cylinder or a faint smell near the unit, because it points the service in the right direction. From there the gasfitter cleans the burner, tests gas pressure, ignition and the TPR valve, checks the flue and draught, sets the tempering valve to 50 degrees Celsius, checks the anode, flushes sediment or descales, and tests for leaks and carbon monoxide. Worn parts are listed in a short report.

Imagine the burner starts cutting out about a year after we installed your new system. You call us, we work out whether the fault lies with the unit or with the installation, and either way you are not left to sort it out alone. A defect in the unit goes through the manufacturer’s warranty, which we help you lodge, and anything to do with our fitting is covered by our workmanship guarantee.

Imagine you walk past the system and catch a whiff of gas. Do not try to relight anything or find the fault yourself. Close the gas isolation valve, get everyone outside and call a licensed gasfitter from a safe distance.

Plenty of homeowners worry they will pick the wrong type, but either system works well when it is matched to the home. If you are replacing an existing storage cylinder, a like-for-like swap is often the simplest path, and if you want to change to continuous flow, we check the gas line and water pressure first so there are no surprises. The decision is yours and we will give you a straight comparison either way.